BUILDING CABINETS | Episode 13

Building cabinets in my garage series. Episode 13. This series follows the full build process of a large set of stain grade maple laundry room cabinets. In this video I start to use up the scraps and complete all of the hang rails and bracing. The edge banding I put on the hang rail on the upper cabinets is a pre-glued/ pre-finished birch tape that is a perfect match with the pre-finished plywood on the rest of the set. (A 250 ft roll is around $38 )The edgebanding has to be covered with a cloth when ironing or the finish will burn. I’m using a solid carbide spiral upcut bit on the router table to flush the edgebanding. There’s usually just enough scrap plywood left over to make all of these bracing parts.

It is what it is.

Thanks for watching!

Drop me a comment!

MUSIC: “Dog walk, Cadmen Lock, Tonight, and One Note” all by David Cutter Music.

@dcuttermusic / http://www.davidcuttermusic.com

Nathaniel Passmore - August 23, 2019

Hi

    Slow and Expensive - August 23, 2019

    Hey Isaac!

Mosca Woodworking - August 23, 2019

glad to see you back Tony! nice trim router table you have

    Slow and Expensive - August 23, 2019

    Thanks Alberto!

Make Things - August 23, 2019

Hey Tony, I’ve missed you buddy! Cabinets are looking great man!

    Slow and Expensive - August 23, 2019

    Thanks Rob!

paulsmessyworkshop - August 23, 2019

Tony, I sure learn a lot from watching you channel, thanks a lot. That being said, do you really need to clean up and put things away? Don’t you think that is going a bit to far? LOL!!

    Slow and Expensive - August 23, 2019

    Haha! Thanks Paul! A mild case of o.c.d. keeps me on the spree πŸ™‚

Twisted Woodshop - August 23, 2019

Hey! Glad to see your still at it! Congrats on the success of the channel too. Much deserved. Your projects and editing are too good and it was only a matter of time!

    Slow and Expensive - August 23, 2019

    Thanks Dave! I appreciate it πŸ™‚

Irish Chippy - August 25, 2019

Hi Tony. Glad to see you are back again, making great stuff

    Slow and Expensive - August 25, 2019

    Hey Chippy! Thanks man πŸ™‚

samlol23 - August 27, 2019

it may have taken you longer to edit the footage than build the cabinets…..great job

Mark McCluney - August 27, 2019

Boysoboys, those cabs are really built. And all that synchronised editing – just fabulous. Great vid Tony, you knock me out every time.

    Slow and Expensive - August 27, 2019

    Thanks Mark! I really appreciate it πŸ™‚

Richard T - August 27, 2019

Awesome videos Tony. I might need you to build me a desk sometime.

    Slow and Expensive - August 27, 2019

    Thank you! Sure

Nicolas Salgado - August 28, 2019

Great job

TNSamShiner - September 11, 2019

9/11/2019 We didn’t see No Finishing or Hanging the cabinets. Where is those videos?

    Slow and Expensive - September 11, 2019

    Still working on those. There’s a ton of footage left to edit and my computer recently went off the rails. I had it repaired a couple weeks ago and I’m just now getting back into a groove with things. I hope to get the next one up soon.

Comments are closed

Tweet
Pin
Share